ProyectECU Kraken
New range of ECUs that ProyectECU has for you
Kraken 8
A programmable computer with advanced and powerful options and configurations!
Full Stand alone motor control, It is programmed with TunerStudio.
Spartan Stand Alone Motor Controller with new 7x faster processor!!
Full sequential injection and ignition up to 8 cylinders (Possible to configure and reuse for more outputs)
The ECU comes ready to use VR (reluctant), Hall or Optical type CKP Sensor.
Consists of internal 4Bar MAP (up to 45psi)
- DBW Integrated Control
- 2X Knock sensor inputs
- VVT outputs by angle (12V)
- VR inputs with adjustable sensitivity per RPM
The kit includes:
– Spartan ECU
– 1m 24-wire harness
- USB Cable
– Software and manuals in downloads area
List of Inputs and Outputs
-16×16 3D fuel and ignition maps, with base of either TPS (Alpha-N) or MAP (Speed Density)
-Decimal resolution for Timing advance
-After Start Enrichment
-Rev limiting (Spark based, hard and soft)(flames, explosions)
-Cranking specific enrichment, dwell timing and advance
-General logging through TunerStudio
-High speed tooth logging
-TPS calibration through TunerStudio
-Sensor calibration through TunerStudio (Coolant, IAT and O2)
-Warm Up Enrichment (WUE)
-TPS based acceleration enrichment
-Knock inputs
-VR sensing with sensitivity adjustment
-Fuel pump activation/deactivation (With priming)
-Air contitioner control basic
-General outputs control (main relay, aux relays)
-Alternator control
-Battery voltage compensation for dwell and injectors
-Modular wheel decoder support
-Closed/open loop boost control
-Closed/open loop VVT control
-Closed/open loop O2 control
-Various CAN functions/protocols supported
-Deceleration fuel cut-off (DFCO)
-Launch control
-O2 based autotune (Registered version of TunerStudio required)
EN 
ES_MX